Mounted "twister" today to see where I could weld a support bracket so all the weight wasn't hangin off the exhaust ports.
My best bet is the cross member right behind "twister". I may remove the round bar and replace with square stock. Or may decide not to do anything at all.
I think this would be my last frame mod before it would be ready for powder. I am not doing any "beauty" work though until the dryfit is done.
My best bet is the cross member right behind "twister". I may remove the round bar and replace with square stock. Or may decide not to do anything at all.
I think this would be my last frame mod before it would be ready for powder. I am not doing any "beauty" work though until the dryfit is done.
Comment