Mounted "twister" today to see where I could weld a support bracket so all the weight wasn't hangin off the exhaust ports.
My best bet is the cross member right behind "twister". I may remove the round bar and replace with square stock. Or may decide not to do anything at all.
![](http://www.robwilton.com/gsr/turbmount.jpg)
I think this would be my last frame mod before it would be ready for powder. I am not doing any "beauty" work though until the dryfit is done.
![](http://www.robwilton.com/gsr/turbol.jpg)
![](http://www.robwilton.com/gsr/turbor.jpg)
My best bet is the cross member right behind "twister". I may remove the round bar and replace with square stock. Or may decide not to do anything at all.
![](http://www.robwilton.com/gsr/turbmount.jpg)
I think this would be my last frame mod before it would be ready for powder. I am not doing any "beauty" work though until the dryfit is done.
![](http://www.robwilton.com/gsr/turbol.jpg)
![](http://www.robwilton.com/gsr/turbor.jpg)
![](http://www.robwilton.com/gsr/turbot.jpg)
Comment