just got the clear tail light with the integrated turn signals in it, bee stinger type and i gotta say i like it. i zip-tied my license plate to the back and drilled a hole in the plastic under the seat for the license plate light. all in all, it looks pretty good. i just sanded down the plastic to match the back plastics. not a bad look on a kat. just wanted to share my excitement with the rest of you kat lovers
Ad Widget
Collapse
Announcement
Collapse
No announcement yet.
X
-
How do you wire it up???? Just got mine and will work on it Saturday, but what wires go to what? Sure I can figure it out if I have a Few BEERS and look at it long enough, but some quick details would be helpful!!!!99 Ford F150 4x4
04 Mustang GT
2010 Camaro SS
06 GSX600F
sigpic
Comment
-
OMG I Absolutely LOVE IT... im thinking of doing something with mine as well but I guess now I know what to do, where did you get the clear lights and was it hard to replace it? I also have my plates on zip-tied with plastic. thank you for the info2002 Suzuki GSX-750F
2007 Subaru Impreza
2010 Nissan Altima 2.5S
Comment
-
i forget what color the wires coming off the light are but here is a wiring diagram i used to figure it out.
Originally posted by akeithan View PostOMG I Absolutely LOVE IT... im thinking of doing something with mine as well but I guess now I know what to do, where did you get the clear lights and was it hard to replace it? I also have my plates on zip-tied with plastic. thank you for the infosigpic
If everyone rode motorcycles there wouldn't be so many idiot drivers
Comment
-
Yall arent any help! LOL! I am understanding the plate light and the connector for the brake/tailight parts, but the turn signal wires, how are they wired up there are only 2 wires, no ground wires.... How do they hook up!!!!!??????????????99 Ford F150 4x4
04 Mustang GT
2010 Camaro SS
06 GSX600F
sigpic
Comment
-
Go to Clear Alternatives web site , the wiring info for the unit is there some place
If I remember from mine , it uses the same ground for tail /brake and signal
Ground is groundBlood , its in you to give! http://www.blood.ca/
Comment
-
Originally posted by csjcsj View Postso basically the signals are grounded through the brake light? All ya have to do is hook up the 2 single wires for the signals to the power source from the OEM wiring harness???
I can check for sure in a couple months when mine comes out of storage
I tried looking at CA site but all links are dead????
Take a picture of the LED board and post , may refresh my memory better
found this and I was right
Got a tweaked piece of plastic? Some roughed up paint? Here's the place to get some tips on repairing your Suzuki Katana.
SO just use the + wire from the bike signal harness to the board (it grounds itself form the brake and tail light circuit)
The + should be the solid color wire (the - will have a white strip or dots )Last edited by rexazz2; 12-11-2010, 02:08 AM.Blood , its in you to give! http://www.blood.ca/
Comment
Comment