If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
Put the engine back in my Kat and took it for a short test ride to make sure the trans is working like it's supposed to. Just need to give the carbs their annual spring cleaning to get rid of the rust plugging the pilot jets, and find a new back tire, and it should be good to go.
Finished shovel chop by removing the turn signal stalks, leaving just enough to keep the license plate in place. Turned the license plate bracket upside down to give the plate a little bit of a rake. Completed my DIY signal/taillight integration.
sigpic
Signature was getting too long, check my garage for list of mods.
Finished shovel chop by removing the turn signal stalks, leaving just enough to keep the license plate in place. Turned the license plate bracket upside down to give the plate a little bit of a rake. Completed my DIY signal/taillight integration.
I just RE-did my shovel chop because the first go around didn't mount up very well. Looks much better now.
I also put on SS braided brakes lines last weekend.
Comment