So today I was bored and decided to install a built in garage door remote.
For my project i needed a small button, some wire, a remote, solder, and a soldering iron.
The first thing I did was to take apart the remote. Luckily my remote uses a 12v battery so this is a very easy project. After you take it apart soder wires to the battery leads, make sure + goes to + and - to -.
To wire it into the bike I used the running light. I did this so that the remote would only work when the bike is on.
Now I picked out where I wanted the button to be.
Now the button is on and it works.
For my project i needed a small button, some wire, a remote, solder, and a soldering iron.
The first thing I did was to take apart the remote. Luckily my remote uses a 12v battery so this is a very easy project. After you take it apart soder wires to the battery leads, make sure + goes to + and - to -.
To wire it into the bike I used the running light. I did this so that the remote would only work when the bike is on.
Now I picked out where I wanted the button to be.
Now the button is on and it works.
Comment