Hey all how is everyone? I have run into a snag on my custom exhaust setup. I was planning on using my midpipe from the vance and hines system that was on the bike, but its not going to work with the new muffler because the midpipe is the same diameter as the entrance to the can, and trying to shrink the metal has been to no avail, so I am wondering what other midpipes would work with a Vance and Hines header? I have a lot of play with the muffler because it uses a strap to bolt to the body, so I can move it foward and backward a good amount, I just need something thats going to come close so I can clamp her down. The muffler entrance has an inside diamter of 2in, so I would need a pipe that would fit into that.
This is the original post that I had started. I can get one made from scratch, but if I could save a few dollars by getting off ebay, that would be grand. Thanks in advance for the help!
craig
This is the original post that I had started. I can get one made from scratch, but if I could save a few dollars by getting off ebay, that would be grand. Thanks in advance for the help!
craig
Comment