If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
I had the choke out when I started the bike and when I put it back in it had no effect.
What can I do to try and resolve this problem?
Thanks
Remove the tank, disconnect the choke cable from the carbs and handlebar. Pull it out, and inspect fully to make sure it's working correctly. Not hanging, grabbing, and using 2 fingers on one end you can easily and freely move it back and forther in the sheath. If not, clean and lube... if that doens't fix it, then replace.
If not the cable (it's working fine) then check the rail the cable attatched too to make sure it's not bent. If not bent, move it back and forth. If it does not close on it's own when you "open" the choke levers, then you have sticking plungers. Most likely due to corrosion or deposits. This means you need to seriously clean the carbs.
Until you can do what Kreylyn said, if you just want to get it to start, you can put a zip tie on the side of it, accessible from the left fairing hole behind the petcock, and manually push it to the right to turn it off if it is sticky.
Comment