Ok I am a bit baffled here. I have LED turn signals to start. I have a pre 750 they are attached to. Here are symptoms:
The bulbs hooked directly to a battery show very bright, quite nice. So they work.
I have followed the wiring diagram, have it wired up. What I am getting is VERY dim, no flashing. The switch is directing power where it needs to be, for each side.
I went on EBAY and got an "LED Flashing" unit, installed, and same condition. I know that with the LED, it should be bright, but flashing too fast. From what I can get out of the wiring diagram, the power goes from the turn signal relay, to the switch, to the bulbs to ground and back.
The bulbs hooked directly to a battery show very bright, quite nice. So they work.
I have followed the wiring diagram, have it wired up. What I am getting is VERY dim, no flashing. The switch is directing power where it needs to be, for each side.
I went on EBAY and got an "LED Flashing" unit, installed, and same condition. I know that with the LED, it should be bright, but flashing too fast. From what I can get out of the wiring diagram, the power goes from the turn signal relay, to the switch, to the bulbs to ground and back.
Comment