OK, so I'm finally started on my projector retrofit. I picked up a 3" Bosch projector from flea-bay and a used headlight housing from the same source. I get the projector in and start tearing it down to get rid of all teh extra bits (like the auto-levelling gear, etc.) and then start looking at bulb/ballast kits. That's when I realize that D1S bulbs (which this projector is set up for) are EXPENSIVE! So I scratch my head a bit and realize that the box that holds the bulb base comes off, leaving a round base on the reflector with slots for a retaining ring.
Question is: can I install a D2S bulb using a retaining ring like this:
on this:
(See attachment)
Question is: can I install a D2S bulb using a retaining ring like this:
on this:
(See attachment)
Comment