Bike runs fine but will cut out and die on a bump or sometimes putting it in gear.
Runs fine in neutral and on the center stand.
Sidestand switch shows 0.600 v continuity with the stand up, 0.0 stand down.
Neutral switch reads bout 6 ohm in neutral, 1200+ ohm in gear.
Pulled the neutral switch off and there is a little groove worn in the switch cover from the pin/spring.
Any advice?
Runs fine in neutral and on the center stand.
Sidestand switch shows 0.600 v continuity with the stand up, 0.0 stand down.
Neutral switch reads bout 6 ohm in neutral, 1200+ ohm in gear.
Pulled the neutral switch off and there is a little groove worn in the switch cover from the pin/spring.
Any advice?
Comment