Ok, I would like to have my bars a little lower. The stock position is a little uncomfortable for me, so if they were lowered about 1"-1 1/2"...they would be perfect.
Now...I've been doing a lot of research, and reading through this site. From what I understand, if I use the same year upper from a 600...it should work properly. So I will explain what I think I understand, and if I'm wrong...please feel free to correct me.
I have a 94 750. The upper consists of two parts...the same year 600, the upper is one part with clip ons. So, in order to properly do the swap...I would remove both parts of the 750 upper triple, and replace with the 600 one. That should leave enough space at the top of the forks to place the clip ons.
In essence...the new clip ons will rest at the same height on the forks, as the 750 ones, but the bars will be lower.
Am I correct in assuming this? Thank you.
Now...I've been doing a lot of research, and reading through this site. From what I understand, if I use the same year upper from a 600...it should work properly. So I will explain what I think I understand, and if I'm wrong...please feel free to correct me.
I have a 94 750. The upper consists of two parts...the same year 600, the upper is one part with clip ons. So, in order to properly do the swap...I would remove both parts of the 750 upper triple, and replace with the 600 one. That should leave enough space at the top of the forks to place the clip ons.
In essence...the new clip ons will rest at the same height on the forks, as the 750 ones, but the bars will be lower.
Am I correct in assuming this? Thank you.
Comment