Just a quick one all,
I've stripped some carbs, but I'm getting very different instructions on how far out the air mix screws should go.
I'm sure in previous threads "2 and a half turn out" are suggested.
Service manual say "1 and a quarter".
Carbs 101 says "1.5 to 2 turns".
Is this trial and error? It seems like a big job to adjust them each time?
Carbs are standard (not jetted).
Thanks.
I've stripped some carbs, but I'm getting very different instructions on how far out the air mix screws should go.
I'm sure in previous threads "2 and a half turn out" are suggested.
Service manual say "1 and a quarter".
Carbs 101 says "1.5 to 2 turns".
Is this trial and error? It seems like a big job to adjust them each time?
Carbs are standard (not jetted).
Thanks.
Comment