So i took the tank off my project bike with a gallon of gas or two in it. Had it set to "on" so no gas would come out. (which is still wierd to me cuz i'm used to working on my Harley which is gravity fed)
Figured i'd drain the gas by switching it to prime and letting it flow out.... but it didn't. Even when i tilted it toward the petcock. I could shake it back and forth and a little would come out. I'm thinking it's hosed... or was i supposed to open the gas lid maybe?
Did i mention i can turn the knob 360 degrees... don't think that's supposed to happen either. Maybe this has something to do with the hard starts and loss of power while on the throttle?
It's getting replaced. Just wanna know if it shoulda been flowing.
Figured i'd drain the gas by switching it to prime and letting it flow out.... but it didn't. Even when i tilted it toward the petcock. I could shake it back and forth and a little would come out. I'm thinking it's hosed... or was i supposed to open the gas lid maybe?
Did i mention i can turn the knob 360 degrees... don't think that's supposed to happen either. Maybe this has something to do with the hard starts and loss of power while on the throttle?
It's getting replaced. Just wanna know if it shoulda been flowing.
Comment