So I just installed a factory pro 3.0 jet kit on my 600 and it ran beautiful. Shortly after I washed the bike and now cylinders 1 and 2 are dead. I changed cdi's and coils and still the same. What could be wrong, I'm lost. I have not changed plus yet. Thanks
Ad Widget
Collapse
Announcement
Collapse
No announcement yet.
X
-
Shop vac the plug holes, leave somewhere warm overnight and try it in the morning.
Comment
-
It grounds out the plug wire to the engine. No voltage across the plug means no spark.
Comment
-
If that is the case, you need to clean out the drain holes. Each one has a drain to prevent that from happening.
Krey93 750 Kat
Modified Swingarm, 5.5 GSXR Rear with 180/55 and 520 Chain, 750 to 600 Tail conversion, more to come. Long Term Project build thread http://katriders.com/vb/showthread.php?t=96736
"I've done this a thousand times before. What could possibly go wron.... Ooops!"
Comment
-
So I'm guessing the water was the problem. I started it up today and it seemed fine. But I changed plugs and clipped the wires back about an inch and its running perfect, if not better than before. So thanks for the help guys. I guess I learned a can't wash my bike lol
Comment
Comment