So, i went out today to start the bike and smelt gas. When i took the fairing off gas was leaking from in between 1&2. I pulled the gas tank off and it looked like the fuel line had backed itself off the inlet to the carbs a little. I pushed it all the way down till it stopped.
1. There is a ring around the fuel line, does the hose stop there or need to be pushed over this. I didnt get a chance to get the clamp back on because i couldn get my hand down there yet. I started the bike and tried to get down there to look real quick. It drips pretty steady, but does not appear to be comming from the hose. It hasnt been rode within the last couple of weeks, just started every weekend and no problems till todays startup.
When i feel in between the carbs it is wet around where the rail goes into the carb 1. I cannot see anything where it is comming out specifically. I can only see it dripping off the underside of carb 1.
1. There is a ring around the fuel line, does the hose stop there or need to be pushed over this. I didnt get a chance to get the clamp back on because i couldn get my hand down there yet. I started the bike and tried to get down there to look real quick. It drips pretty steady, but does not appear to be comming from the hose. It hasnt been rode within the last couple of weeks, just started every weekend and no problems till todays startup.
When i feel in between the carbs it is wet around where the rail goes into the carb 1. I cannot see anything where it is comming out specifically. I can only see it dripping off the underside of carb 1.
Comment