When setting float height, Is the measurement of 14.6mm the difference between the lip of the carb and the top (bottom technically) of the float or the difference between the lip of the carb and the ridge on the side of the float?
I'm ready to throw the carbs back on the bike, but I want to make sure I haven't set the floats too high versus too low. If it's to the bottom of the float I don't expect that to be a problem as I'm closer to 20mm. I can't get near 14.6 unless I forcibly hold the floats against the top of the bowl with my finger. However if it's the ridge on the float I'm closer to 10mm.
I'm ready to throw the carbs back on the bike, but I want to make sure I haven't set the floats too high versus too low. If it's to the bottom of the float I don't expect that to be a problem as I'm closer to 20mm. I can't get near 14.6 unless I forcibly hold the floats against the top of the bowl with my finger. However if it's the ridge on the float I'm closer to 10mm.
Comment