If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
[edit] a can of carb cleaner should work - stick the stray thing in the hole and spray. then replace the screw.
+1 to that.. I had really good sucess with that.
Can Special K help with the spring?
The only thing to worry about with the Snyc port o-ring is
that it isn't too fat..
This could twist the cap
What do you mean "limit itself" ? Like it WON'T go past 4K ? Or more like it stumbles around there . There are no "mid jets" . You got pilots , and you got mains . The needle controls your midrange mix . If it's adjustable (not stock) , maybe try fiddling with them and see if it does anything .
Would it go past 4K BEFORE you messed it up ? Guess it's time to go back in there and see if anythings missing/not screwed down enough (I forgot to close my drains once and had it IDLE at 4K ...) . Yeah , SOMETHING's not right , for sure ....
Well, these are actually carbs I bought not to long ago, so I haven't been inside of them...at least not the bottoms, but what specifically would make it just limit itself to 4K?
Comment