So, this will be a stupid and easy question, but for the life of me I can't seem to figure out what im doing wrong here.
cut to the chase: when i took my carbs off i replaced the throttle cable..after installing the new cable and putting the carbs back on the bike there is now too much play in my throttole..turns too much before actually pulling the cable.
i can see on the body of the carbs there is an ajuster that i can unscrew out...this helps..but when i do this the trottle cable becomes weirdly loose at the carb body end...it almost appears like it needs 1 more nut that could be loosened, then the cable could be ajusted then the nut could be tightened again thus locking your new "setting" in place.
I've looked at both the new cable and the one i removed, they are identical..and both only have 1 nut down near the carb body. there is no way to get any other nut on to the cable because the cable ends prevent putting that nut on.
I can't find anyone else stupid enough to be having the same problem...i need a sanity check pleeeeeaaassee!!!
thanks so much
cut to the chase: when i took my carbs off i replaced the throttle cable..after installing the new cable and putting the carbs back on the bike there is now too much play in my throttole..turns too much before actually pulling the cable.
i can see on the body of the carbs there is an ajuster that i can unscrew out...this helps..but when i do this the trottle cable becomes weirdly loose at the carb body end...it almost appears like it needs 1 more nut that could be loosened, then the cable could be ajusted then the nut could be tightened again thus locking your new "setting" in place.
I've looked at both the new cable and the one i removed, they are identical..and both only have 1 nut down near the carb body. there is no way to get any other nut on to the cable because the cable ends prevent putting that nut on.
I can't find anyone else stupid enough to be having the same problem...i need a sanity check pleeeeeaaassee!!!
thanks so much
Comment