Just a quick question since I cant seem to find the answer in the Haynes manual and the Clymers I ordered isnt here yet.
On a '90 750F, does the vacuum fitting from carb #3 go to the vacuum fitting on the petcock?
Clarification: Carb #3 is defined as the 3rd card from the left if you were sitting on the bike normally.
I ask because the fitting is broken off of carb #3.
I just bought the 750 and Im going through it and troubleshooting a possible fuel delivery problem.
On a '90 750F, does the vacuum fitting from carb #3 go to the vacuum fitting on the petcock?
Clarification: Carb #3 is defined as the 3rd card from the left if you were sitting on the bike normally.
I ask because the fitting is broken off of carb #3.
I just bought the 750 and Im going through it and troubleshooting a possible fuel delivery problem.
- The bike would start, but it wouldnt stay lit unless you throttled it.
- It also appeared the PO was running it from PRI to deliver fuel to the carbs.
- It also had a pretty bad fuel leak from the lines so those have been replaced already.
- Choke cable was perma stuck and wouldnt budge
- Replaced fuel lines
- Disassembled and cleaned the petcock and replaced internal o-ring
- Ordered new choke cable
Comment