Getting the throttle cable OFF is the easy part , it's getting it back ON again that sucks . I usually take the throttle pod apart , put it back on at the carbs with the extra slack , THEN thread the cable back around the throttle tube . Seems to work easier that way .
Ad Widget
Collapse
Announcement
Collapse
No announcement yet.
X
-
Yeah, the 98+ is a real bear without a set of forceps -- in part because it's dual throttle cables (push-pull). I've got putting it back down to about 30 - 90 seconds per side with the 8" curved forceps (the secret is all in the clamping lock and where you hold the cable).
Cheers,
=-= The CyberPoet
Comment
-
Hi, I have one of the carbs apart, the float bowl was filled with dark rusty sediment and which was plugging up the drain screw. I am having trouble locating the main jets and also what is the emulsion tube? what exatcly am I suppose to drill out on the carb with the brass fitting?
Sorry for all the questiongs but this is the first time doing this and what to get every thing cleaned right.
thanks
Comment
-
If the float bowl was filled with dark rusty sediment, your primary problem to fix first is tank rust, because otherwise any cleaning you do to the carbs will be for nothing (it'll come right back as soon as the tank is used again).
CyberPoet's "How to correct a rusty motorcycle gasoline tank".
We'll go into what needs to happen at the carbs once that's done
Cheers,
=-= The CyberPoet
Comment
-
Originally posted by stevend135I am having trouble locating the main jets and also what is the emulsion tube? what exatcly am I suppose to drill out on the carb with the brass fitting?
The main jet is kinda hard to miss , buddy . It's this brass thing with a hole in it and a slot for a screwdriver . It's RIGHT there in the middle sticking out .
The emulsion tube (or needle jet as I think the fiche diagrams call it ) is what the main jet actually screws into , and what the needle sits down in from the top .
The caps aren't actually IN the carbs , they sit just outside the bowls , and near the engine side . If the caps are there , you can't miss 'em . They're these round , brass things maybe 1/4" in diameter and they seem to have a TEENY tine hole in them already usually .
Comment
Comment