Tweet
ok so checked the valves...they were at spec of .005 which was stated....so i checked the float height by attaching a tube to each carb and letting out that little allen key...2 carbs show level with the gasket one is higher than the gasket by like 2 mm and another doesnt even fill half the bowl...so i have a friend setting the floats for me so im hoping this works
- If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.
Working...
Comment