i need assistance installing integrated tail lights on a 05 katana 600.im not sure where the sets of wires connect to.1 set has 1 solid black and 1 black and white wire,the other set has 1 yellow wire and 1 blue wire.what are these wires and what do i connect them to.its also a set of wires thats connected together at the end but i know they go to.help me with the other 2 sets.
Ad Widget
Collapse
Announcement
Collapse
No announcement yet.
X
-
the yellow and blue are for the turn signal lights... connect blue to one side & yellow to the other & the ground together.. the connects are black w/ wht goes to red, white w/ blk goes to white & brown goes to black...The only modification that you will need to do is run a new line to your plate light.. (that's what I had to do anyway)... Hope this helps.. good luck...
Comment
-
-
yes the 2 from the bike on each side... (turn signal) you connect the yellow to the right side of your bikes turn signal wire, then you take the blue wire & connect it to the left side turn signal wire and take the black wire fron the bike of each turn signal and connect those two together..
Comment
-
Originally posted by roe1880 View Postyes the 2 from the bike on each side... (turn signal) you connect the yellow to the right side of your bikes turn signal wire, then you take the blue wire & connect it to the left side turn signal wire and take the black wire fron the bike of each turn signal and connect those two together..
Comment
-
the wires with the black covering and the white tip,i know where that goes.i dont know where the yellow and blue wires go.i also dont know where the solid black and black w/ white stripe go.the black and black w/white is connected directly to a light bulb which i believe is a license place light.Attached Files
Comment
-
Brake is the white w/black strip wire--- hook to red wire (from light)
running lights is brown wire--- hook to white (from light)
Ground is black w/white wire--- black to black w/white (from light)
left turn signal is black & black w/white---blue to black (turn signal, from light)
right turn signal is green & black w/white--- yellow to green (turn signal, from light)
the black wire with white line is the ground to the turn signals which get connected together
this is the set up that has worked with my bike and also another fellow member that had the same problem and we hooked up today and got his setup and working as well.. we both can't figure out how to connect the plate light to the system and I will most likely just run a button/switch direct from the battery that I can turn on & off whenever..
Comment
-
what do i connect the yellow and blue wires to?the turn signals i currently have has 2 wires on both sides.each side has 1 solid black and 1 black w/ white.do i put the black and black w/white wires together and connect them to the yellow and do the same theing on the other side for the blue?
Comment
-
Originally posted by 38114vet View Postwhat do i connect the yellow and blue wires to?the turn signals i currently have has 2 wires on both sides.each side has 1 solid black and 1 black w/ white.do i put the black and black w/white wires together and connect them to the yellow and do the same theing on the other side for the blue?
Comment
-
i connected the yellow wire to the solid black wire on the left signal and the blue wire to the solid black wire on the right signal.the lights come on but when i apply the brake,the light cut off instead of getting brighter also when i turn on the turn signal in either direction the whole light blinks.what could be the issue?
Comment
Comment