Well I got my Competition Werkes Fender Eliminator Kit a few weeks ago and I fell a little ripped off $126 for 2 thin pieces of sheet metel, some hardware, and rear turn signals which are to big.
But I did want it to look the best and from some of the cob jobs I see people do on here for a few bucks,
I think it might be worth it.
The instructions seem pretty straight forward only 8 steps from start to finish.
I didn't install it yet because I have been dredding having to cut my fender
What did you find worked best to cut your fender ex. dremmel, sheetrock knife, hacksaw,etc.
Also can I easily change my rear tail lights later if I want Smaller ones?
But I did want it to look the best and from some of the cob jobs I see people do on here for a few bucks,
I think it might be worth it.
The instructions seem pretty straight forward only 8 steps from start to finish.
I didn't install it yet because I have been dredding having to cut my fender
What did you find worked best to cut your fender ex. dremmel, sheetrock knife, hacksaw,etc.
Also can I easily change my rear tail lights later if I want Smaller ones?
Comment