1. pieces that have good factory paint / clear, but where I'm filling a couple of holes (Drilled). I know I need to sand down the areas to be repaired. Is 80 grit too much? IF so what grit is recommended?
2. Pieces that have 'questionable' paint on them in rough shape. What grit should I use for the whole piece? Will 150 grit be enough? Do I need to go down to the bare plastic, or just until it's smooth?
3. Once I have repaired areas, I was hoping to use an aerosol 2K primer / filler on the entire piece. On repaired areas what grit should I use PRIOR to applying 2K primer / filler? On areas that didn't need repair, is 320 grit okay before primer application?
4. Once primer is applied to the entire piece, If I remember correctly 400 wet for solid colors and 600 wet for metallic colors before base coat application is what was recommended...am I on track?
Thanks for the help...it's greatly appreciated.
2. Pieces that have 'questionable' paint on them in rough shape. What grit should I use for the whole piece? Will 150 grit be enough? Do I need to go down to the bare plastic, or just until it's smooth?
3. Once I have repaired areas, I was hoping to use an aerosol 2K primer / filler on the entire piece. On repaired areas what grit should I use PRIOR to applying 2K primer / filler? On areas that didn't need repair, is 320 grit okay before primer application?
4. Once primer is applied to the entire piece, If I remember correctly 400 wet for solid colors and 600 wet for metallic colors before base coat application is what was recommended...am I on track?
Thanks for the help...it's greatly appreciated.
Comment