Tweet
Been trying to find information on this for a few weeks, checking wiring diagrams, K1 tach ppr and asking if anyone had done the conversion and the results etc.
Well after pulling my hair out for several days I changed the wording of my search, bingo, gauges not clocks...doh
Will need a speedo healer to correct the difference (tbh if the difference is just a few mph and its linear I will leave it as it is) and the fault codes will be permanently displayed (I have found posts on other forums where programmers are developing software to replicate the signal to turn them off) but I have a plan for those (carbon fibre clock surround with fault part of screen covered)
Anyway, if you fancy upgrading your clocks, and want to stick with factory components have a read on the link below
Well after pulling my hair out for several days I changed the wording of my search, bingo, gauges not clocks...doh
Will need a speedo healer to correct the difference (tbh if the difference is just a few mph and its linear I will leave it as it is) and the fault codes will be permanently displayed (I have found posts on other forums where programmers are developing software to replicate the signal to turn them off) but I have a plan for those (carbon fibre clock surround with fault part of screen covered)
Anyway, if you fancy upgrading your clocks, and want to stick with factory components have a read on the link below
