Tail Section Mods

[Pritch]

I'm continuing to work on my fighter project and really want to change out the tail section of my 91 Kat Frame... I've seen a few posts throughtout the streetfighter forums, but looking for more.

Anyone willing to post pics of tail swaps they've done or link me to the build? Any advice for a novice? Any straight across bolt matching swaps?

Any and all advice is appreciated

[Jax]

Here are some from an 89 Kat 600 tail change out:
http://s604.photobucket.com/albums/t...eld/?start=all

Here is my entire albums of this project, still in progress:

http://s604.photobucket.com/albums/tt126/Projectbutana/Raffs%20Pics/

[Waltari]

Well, unfortunately since your kat subframe does not bolt on, there will be NO bolt on swaps. Everything is going to involve cutting and welding. You can go one of two ways, cut off the existing subframe and weld on tabs/supports to allow you to bolt on a donor subframe, or you can completely fab up one of your own design.

[mreedohio]

heres mine a direct bolt up from Wagner's Plastic Technology

[Pritch]

Appreciate the responses. I guess now I need to figure out what rear end I dig and start the cutting and welding! It's just finally getting so nice here, that I don't want to start a long process, eh!

[bob393]

Nice work, I wish mine looked like that!

[JokerZwild]

Not sure about the 600s but my 91' 750 had a bolt on sub frame that was a piece of cake to remove.

[jonezy]

Here are some from an 89 Kat 600 tail change out:

http://s604.photobucket.com/albums/tt126/Projectbutana/Raffs%20Pics/Busa%20Rear%20End%20Weld/?start=all

Here is my entire albums of this project, still in progress:
http://s604.photobucket.com/albums/t.../Raffs%20Pics/

this was very interesting, i'll look forward onto it... +1

[krigs]

Not sure about the 600s but my 91' 750 had a bolt on sub frame that was a piece of cake to remove.

i have a 750 too and I'm looking to swap the tail section if you don't mind me asking what did you do to yours it looks sweet