My brothers bike, a 1994 kat 600 that he just purchased runs great!
The problem is, it wont go.
after searching around for a reason I found a large amount of duct tape on the kickstand used to "engage" the sidestand safety switch. Needless to say it wasnt working very well. After talking to arsenic and others I traced the lines, snipped them and bypassed the switch. (shown here)
This STILL did not fix the problem.
The bike will start fine, clutch engaged and neutral light on. Once you kick it into gear with the clutch engaged it will die just like you do not have the safety switch on. Which I find odd since it has been bypassed....
This is the location of the wires traced from the switch:
Does anyone have any other ideas?
We are at a standstill and dont know what else to do, so we are open to any suggestions!
thanks for your help guys, we're completely lost
The problem is, it wont go.
after searching around for a reason I found a large amount of duct tape on the kickstand used to "engage" the sidestand safety switch. Needless to say it wasnt working very well. After talking to arsenic and others I traced the lines, snipped them and bypassed the switch. (shown here)
This STILL did not fix the problem.
The bike will start fine, clutch engaged and neutral light on. Once you kick it into gear with the clutch engaged it will die just like you do not have the safety switch on. Which I find odd since it has been bypassed....
This is the location of the wires traced from the switch:
Does anyone have any other ideas?
We are at a standstill and dont know what else to do, so we are open to any suggestions!
thanks for your help guys, we're completely lost
Comment