So I tested that my coil was bad, unfortunately, and I ordered some used coils to replace my coil.
I ordered a set of both coils, but when it came the right coil (2,3) was extremely stuck. After getting it off, and breaking some plastic around the coil holes in the process.. i find this - [attached picture]
Its inside all over the coil hole as well. Not just that, but it is from a post kat. I did my research, so I know it will work fine. Here is my question...
I got the left coil as well, and the wires came out cleanly. Can I just use the left coil for the right side? I searched but didnt find a definitive answer. The part numbers are different, so I just wanted to make sure. I'd be using 2 "left" coils essentially.
keywords for future searches: interchangable, swap, switch
I ordered a set of both coils, but when it came the right coil (2,3) was extremely stuck. After getting it off, and breaking some plastic around the coil holes in the process.. i find this - [attached picture]
Its inside all over the coil hole as well. Not just that, but it is from a post kat. I did my research, so I know it will work fine. Here is my question...
I got the left coil as well, and the wires came out cleanly. Can I just use the left coil for the right side? I searched but didnt find a definitive answer. The part numbers are different, so I just wanted to make sure. I'd be using 2 "left" coils essentially.
keywords for future searches: interchangable, swap, switch
Comment