dino jet float hight?

[kamkamdac]

if im cruising between 3.2-4.5k and give it some gas i notice a bit of a bog before i start to accelerate. almost not noticeable at 4.5, more noticeable at 3.2. all in all its not to bad. no noticeable problems in other rpm ranges.

im pretty sure this is a float height issue. current float heights are set around 13.8mm (+- .5mm). does anyone know what the float height for a dino jet kit is supposed to be?

[arsenic]

The float height for dYnojet, are stock heights. Which I'd be happy to tell you what they should be if you SAID WHAT YEAR YOUR BIKE IS.

[muffinman]

My bike did this when it had the K&N that the PO installed.

[kamkamdac]

The float height for dYnojet, are stock heights. Which I'd be happy to tell you what they should be if you SAID WHAT YEAR YOUR BIKE IS.

my apologies, its a 1990

[badwithcomputer]

Take a look at your Eclip position on the needles.

[kamkamdac]

Take a look at your Eclip position on the needles.

they are set the third from the top

[arsenic]

The float heights should be 14.6 +/- 1mm