Help snycing carbs

[Tattered_n_torn]

cant seem to find any how to's on snycing carbs I bought a morgan carb tune but not sure how to hook it up or adjust anything anyone seen any good write ups on this cant seem to find any

[Wild-Bill]

You hook up the carbtune tubes to the vacuum ports which come off the tops of the carbs. The adjustment screws are down between the carbs, on the linkage that connects them. You'll see the linkage turn as you move the throttle. The adjustment screws are the philips-head screws with the springs around them.

[bob393]

There is tons of syncing info here. Give it a quick search.

You do the 3/4 pair first than 1/2 pair and last the center screw for 1/2 to 3/4 pairs to each other. I did mine at about 1500 rpm's and when I was finished I held it at around 3k to check for vacuum leaks.