carb and throttle cable

[doc83]

I WANNA DIE


So today i was working on the bike and it was time to install the carbs.

So i was trying to put the throttle cable back but i didnt figure out how
cause the thing that hold the cable on the carb broke .


AND NOW I DONT KNOW WHAT TO DO HELPPPPPPPP

Please tell me its fixable

[Kreylyn]

I WANNA DIE


So today i was working on the bike and it was time to install the carbs.

So i was trying to put the throttle cable back but i didnt figure out how
cause the thing that hold the cable on the carb broke .


AND NOW I DONT KNOW WHAT TO DO HELPPPPPPPP

Please tell me its fixable

Take a picture of what broke, and post it...

It's probably fixable if you can get a replacement part.

Krey

[HemiKat]

I know its a little late: But I think its easier to have the carbs off the bike and upside down to put the cable on.

[doc83]

[HemiKat]

Did the end beak off or is it just bent? Im guessing even with that little bit missing the cable will still be held in place with the groove. Finish throwing it on and see what happens, Its probably okay.

[doc83]

one of the side broke

if i twist the throttle i dont know if the cable will hold in place

i have a katana 750 laying in my friend garage. The carbs look the same
Do the have different configuration?

[HemiKat]

Youll have to go onto Ronayers.com and compare the part numbers.

[doc83]

Not exactly the same.

What can i do with that? 750 Carb?

[RedKat91]

how do you get the cable out of that spot? I'm stuck right now trying to get my cable out of there.