Popping sound question

[smitty600]

So I was thinking of removing the Cali Emission crap from my 750, then I did some searching. I found a thread on a similar issue. In it it says to get the block off plates and connect the vac hose from #4 to tank. everything else should be ok to remove... Sounds good.

In the mean time I have a popping sound when I release the throttle. It is bad till It warms up, then not as noticeable. I still have all the emissions stuff hooked up. but nothing going to the headers since I have a full Hindle exhaust on it.

Question is, do you think that the hoses not being hooked up are whats causeing the popping? The bike runs great, idles at 1200..

[Tmod]

Did you rejet the bike when you put that full hindle on?

Tmod

[smitty600]

Nope, was told it was already jetted. Like I said besides the popping, it runs great... Even had it up to 120 one day to see how it would run..

[Tmod]

Try turning the A/F screws out 1/4 turn and see if it is better.

Tmod

[the wind]

sounds like a exaust leak to me.

[Malloc]

its becuase i leaned out the engine becuase of the jet kit (used too much gas)

[smitty600]

Thanks for the info Malloc... Thanks for all the suggestions guys..

[VifferJim]

Try turning the A/F screws out 1/4 turn and see if it is better.

Tmod

I have the same problem - just a little burble on decel. This will clean it up nicely.

[steves]

I think you can also try raising the needles a clip, but I'm not expert on tuning.

Are you running 87? The Bandit pops like crazy on super, so I started just putting regular in.