clutch torque

[quadturbo]

can anyone tell me what the clutch plates need to be torqued down to for a 90 600?

[mcmahonm]

Not sure off hand but the PDF manual is here - GSX600F

http://www.files.michaelmcmahon.org/

[bigbike-r]

arond 11 13 for the 4 plate bolts

[bigbike-r]

in the manual
clutch sleeve hub nut..........60-80 Nm (43.5 to 58ft-ibs)

clutch spring bolts...........11-13Nm (8.0 - 9.5 ft-ibs)
when tightening the spring bolts on trhe pressure plate dont forget to do it in a criss cross pattern.

[HS2020]

DO NOT PUT THEM DOWN THAT TIGHT. You will snap them off. I put them to the right torqued and they snapped off. Put them to about 5 ft lbs and leave them. They will tighten up more from use.