If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
I'm no expert on these engines but I would think using a 600 exhaust for a 750 engine would downgrade your performance. Yea I am sure it bolts up nice but the 600 exhaust was designed for a 600 exhaust flow rate. Not saying you won't be able to bolt it up but you may lose a few HP.
The 600 exhaust is a different part then the 750. There might be some reasons it doesn't fit. Remember the fact that the 600 is a sleeved 750 is only the cylinders.
The exhaust bolts to the head. Different part.
I don't know if fitments is the same, but a 600 on a 750 will chock exhaust flow a lot. I have a 750 header on a 600 and that works, so I imagine fitments are the same, but your talking about bad HP cuts.
Comment