If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
Well today I thought that I would go ahead and do the mesh mod on my 00 Kat 600. Took me about 15-20 min to get all the plastic off and another 30 min to do the mesh mod on both pieces. And in less then an hour BAM! Here it is!
What walk through? I went and got the hood vent filter for stove hoods and used that. Kinda did it on my own. I looked around to see how it was done and went from there.
I just relocated the idle adjuster to behind the oil fill "door". I used a washer to replace the thickness of the bracket, so that the screw would not bottom out on the carbs---it goes across all 4 carbs. I just zip tied the bracket to the frame to test this setup. It seems like it will work fine.
Comment