This is what you were looking for. Search for good bye cheezy chain adjusters.
So I finally got tired of those pathetic chunks of metal they call chain adjusters...So me and my buddy came up with these custom replacements.
Adjustable backwards AND forwards, kicking the rear tire forward is eliminated by using a retaining washer on the bolt, and attaching the end plates to the swingarm by screwing the tabs on the tops and bottoms of the plates to the arm.
Rounded edges and a smooth, snug fit inside the swingarm along with 1/8" thick steel design assures support against the axle pinching the swingarm tubing inwards.
The range of movement of the axle through the slots in the swingarm has not been limited but controlled. Axle holes going no farther than the front or rear of the swingarm axle slot. With the axle removed the adjuster does not fall out of alignment making it much easier to slide the axle back in.
Of course these still have cosmetic work to make them look good but ya know...havent got there yet...
I can get dimensions and measurements and stuff if anyone wants to attempt making these themselves
So I finally got tired of those pathetic chunks of metal they call chain adjusters...So me and my buddy came up with these custom replacements.
Adjustable backwards AND forwards, kicking the rear tire forward is eliminated by using a retaining washer on the bolt, and attaching the end plates to the swingarm by screwing the tabs on the tops and bottoms of the plates to the arm.
Rounded edges and a smooth, snug fit inside the swingarm along with 1/8" thick steel design assures support against the axle pinching the swingarm tubing inwards.
The range of movement of the axle through the slots in the swingarm has not been limited but controlled. Axle holes going no farther than the front or rear of the swingarm axle slot. With the axle removed the adjuster does not fall out of alignment making it much easier to slide the axle back in.
Of course these still have cosmetic work to make them look good but ya know...havent got there yet...
I can get dimensions and measurements and stuff if anyone wants to attempt making these themselves
Comment