Tweet
OK so I got the Racetech emulators and springs for my 98 750 and have looked @ Squiggy's writeup. it looks pretty straight forward, when it comes to brazing do I need to braze 6 of the 7 holes shut? 1 above the outer ring of the damping rod, 2 under the outer ring and then there are 3 pinholes approximately 7/8 inch below the upper part of the damping rod? It looks from the pictures that the lower holes are closed off just want to make sure before I start this.Thanks in advance.
- If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.
Ride like it's your last ride 
Working...