If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
replacing fork seals...93 750. all apart, oil out....dust ring, clamp, all off. cannot get the old seals out...don't want to buy the "special" tool...tips?
thanks
nevermind. figured it out.
Last edited by chilln191; 05-14-2011, 03:51 AM.
Reason: Automerged Doublepost
Take the bolt out of the bottom of the fork tube (The one that holds the damping rod in) and then with the dust seal off and the clip out use the fork tube itself as a slide hammer and the tube will pop out. Good time to check the bushings and everything inside as well.
Comment