This is my R1 (02-03) intergrated tail light (Lockhart phillips), $25 used from ebay. My first attempt was a fail. Im not sure if it was a faulty circuit board or if the old style flasher burnt out the LED's, but this one seems to work well. This is probably the easiest integrated tail light there is, its basically plug and play. If you can use butt connectors, you can do this mod.
You only want the circuit board. If you get the whole light, just cut the outter lens, and the black mount off and keep the guts.
Basically just hook up the tail light wire for wire, and place the LED board in the tail light housing. The ground wires going to the tail light are obsolete, just hook up the hot wires of your turn signals to the corresponding blue or yellow wire off the LED board.
When you screw on your cover it will hold the board in place. Youll need to swap out your flasher relay for a variable load, #552 at Oreilly's for $2.99, Plugs right into the Pre harness.
[ame="http://www.youtube.com/watch?v=lBn0gwAEb7w"]YouTube- FILE0045.MOV[/ame]
You only want the circuit board. If you get the whole light, just cut the outter lens, and the black mount off and keep the guts.
Basically just hook up the tail light wire for wire, and place the LED board in the tail light housing. The ground wires going to the tail light are obsolete, just hook up the hot wires of your turn signals to the corresponding blue or yellow wire off the LED board.
When you screw on your cover it will hold the board in place. Youll need to swap out your flasher relay for a variable load, #552 at Oreilly's for $2.99, Plugs right into the Pre harness.
[ame="http://www.youtube.com/watch?v=lBn0gwAEb7w"]YouTube- FILE0045.MOV[/ame]
Comment