removing ignition from yoke

[cintidude04]

could someone tell me what tool is used to remove the ignition from the yoke? I see 2 spot where something is holding it in from the bottom but do not have the tool to fit at the moment.
thankyou.

cintidude04

[mcornelius]

If its a post its called a T40 security torx bit.

[cintidude04]

thankyou, thatll work for my post rolling chasis.
anyone know about the pre's? or if theres any difference?

[cintidude04]

anyone know bout removing the ignition from a '92 600 kat

[hardlydangerous]

same thing

[cintidude04]

that was the first thing I checked and unfortunately it is not

[Kreylyn]

Pre uses a break off security bolt... you pretty much need to drill it out to remove the ignition.

Krey

[cintidude04]

thanks krey, after looking at it real hard in hopes that I could will it off..lol, I figured this might be the case

[jeremy_nash]

I've used a sharp chisel to "make" a slot in it, then used a flat blade screwdriver it out

[Kfreak]

I took a hack saw and cut into the screw heads then unscrewed the screws. It doesn't cause too much damage to the key lock housing.

[cintidude04]

appreciate the help fellas, but this was posted several months ago

[scarface]

I drilled mine out vary carefully not to destroy the threads on the inside.Takes a little time but it can be done.