I started out with a damaged tailight I had plan on replacing anyway so if it did not work no big deal. But it actually works perfect and alltogether took me about 30 minutes and cost less then $5.
All I used was a tube of 5 minute epoxy from walmart, and a couple old makerlights I had layin around and a pop can.
its so simple I dont even really need to write up a how to... just drill two holes and stick the guts from a marker light into the housing and epoxy them into place. Then I cut a couple pieces of aluminum dr.pepper can and epoxied them in place to seperate the tail/brake light from the signals.
looks like this
BRAKE LIGHT
TAIL LIGHT
SIGNAL LIGHT
All I used was a tube of 5 minute epoxy from walmart, and a couple old makerlights I had layin around and a pop can.
its so simple I dont even really need to write up a how to... just drill two holes and stick the guts from a marker light into the housing and epoxy them into place. Then I cut a couple pieces of aluminum dr.pepper can and epoxied them in place to seperate the tail/brake light from the signals.
looks like this
BRAKE LIGHT
TAIL LIGHT
SIGNAL LIGHT
Comment