View Single Post
Old Yesterday, 02:15 PM   #4
Tank Slapper
Suzuki_dog's Avatar
Join Date: Dec 2007
Location: Indiana
Posts: 480


Originally Posted by johnod View Post
Like so, these may not be the right dia. but same look.

I had aftermarket brake lines and did not have to change them, don't know about stock lines.
Also I had to turn them( the bars) around from what I intended so stock master cyl would slide down the bar far enough.
That brought the bars closer, good, but they then hit tank, bad, so I built up the fork stops on lower yoke with a bit of aluminum, and some JB weld.
Easier to undo than if I had welded.

Makes a big difference.
Thanks, I'll check them out.
GS1000SZ, GS1100EZ, GS1000ST (Wes Cooley)
Suzuki_dog is offline   Reply With Quote