Tweet
while i was looking at my bike today i have decided the first thing i would like to do is put some new handle bars on it. How would i go about getting the choke lever and all that jazz on a new set of bars? I am looking at the one peice type of bars for the bike
-
-
your garage says 2007 katana. I am assuming it should read 2006?
I believe you will need to swap out the top triple tree to one that will accept that type of handlebar. I think some of the bandit triple tree's may work. Not sure though. someone else will have some info and post up though. -
i have a pre.. so i just took the clipons off and put some bar risers on and a set of moto bars, i can get pics if you likeComment
-
I used the risers from a virago to make the bars work.
the controls are going to go on just the same as they do on your clip ons,
but you might need to get a longer brake line.
Some days your the bug.....Some days your the windshield.Comment
-
-
yeah photos would help me best so if you have them please post themComment
-
Crazy1 that is exactly what i am looking for those bars are nice and i really like the gauge too do you have any full pics of the bike?Comment
-
Sorry about the wait i don't come on here much.
Here they are theyre tag bars and risers, i had to make the holes bigger to fit the riser bolts, the bars are a little wide and could use some cutting but i like it. o also had to get a longer front brake line
Comment
-
those bars look nice to meComment
-
thanx McChub, here's a thread with a few full pics
Some days your the bug.....Some days your the windshield.Comment
-
Bars
How do those bars work with the fairing???
Any pics?????Comment
-
my suggestion
or
after a crash i cut the lower triangular thing that holds the forks(i don`t know how it`s in english) attached the pieces withn the original handle bars then tighten them directly to the forks
a better look
Live to ride,
Ride KATANA!Comment
-
Comment