I just purchased some clear led turn signals and spliced them in for my rear blinkers, but the blinkers will not blink; they stay solid when i turn them on. The turn signals that i purchased have two wires, a black and a yellow. The only way i can get them to work is when i wire the stock black to the yellow and the stock, white stripe to the black. Is there any way to make my new signals blink instead of being solid.
Ad Widget
Collapse
Announcement
Collapse
No announcement yet.
X
-
I am guessing the bike is a pre 98 ????
locate the flasher and take it to your local auto parts dealer- Napa, Carquest who ever ,I just suggest some one that supplies repair garages because they should have a clue
Get an electronic flasher with the same blade configuration ,cost about $5-10
the LED will not light if polarity is wrong so it looks like that is OK ,It is just that the LED doesnt have enough load to make your old flasher work
the search feature is your friendLast edited by rexazz2; 05-05-2009, 06:15 PM.Blood , its in you to give! http://www.blood.ca/
-
search " pre service manual "
You will be able to find out where the flasher is and wiring diagrams everythingBlood , its in you to give! http://www.blood.ca/
Comment
Comment