Carb diaphragm cover bolts 02

[Seft]

Does anyone happen to have the dimensions including size of the shoulder for the carb diaphragm cover bolts for an 02 600 please?

[Kreylyn]

Does anyone happen to have the dimensions including size of the shoulder for the carb diaphragm cover bolts for an 02 600 please?

Post a pic, I'm sure I have some in a bin but knowing specifically which ones that was at this point is probably low chance.

I do know I always replace all of them with standard metric hex socket or dome caps 16mm long. The shoulder isn't necessary. Pretty sure that's a 4mm sized screw.

Anyways, pic of one and I can pull it out for a full on measurement.

Krey

[Seft]

Anyways, pic of one and I can pull it out for a full on measurement.

Krey

Part 31 from here, https://www.oemmotorparts.com/oem5.a...2=SU4_-2043283 they're round head shoulder bolts, a few were a little worse for wear when I did the carbs so put them back with a little copper grease but want to replace with hex shoulder bolts.

[Kreylyn]

Part 31 from here, https://www.oemmotorparts.com/oem5.a...2=SU4_-2043283 they're round head shoulder bolts, a few were a little worse for wear when I did the carbs so put them back with a little copper grease but want to replace with hex shoulder bolts.

Yeah, I definitely just swap those out with standard 4mm x 16mm stainless socket hex cap screws.

Anyways, here is the measurements...













Krey

[Seft]

Thanks Krey, I'll likely replace with other shoulder bolts as I'm less likely to over torque them and trash the covers!