Tweet
Working on this '97 Kat 600 and it only ran on choke. Went through the carbs and had to pull the mix screw plugs.. Mix screws were set from 2 & 1/8 turns to 0.75 turns from factory? I know common knowledge had my pre Kat 750 set at 2.5 turns contrary to the wiki which has approximate factory setting.. So same here??
-
'95 gsx750F, '79 gs1000e '77 gs750
'83 xj550 maxim
'84 xvz1200
'78 cb750F3 & '76 FLH stroker
'80 fxs80 got whacked, only parts left -
Absolutely. Factory is all over the place. I've seen 1.75 but, that has changed to 2.5 I would perform a drop down adjustment once you get it running well enough. This would allow a more exact adjustment to the A/F mixture.Last edited by 92xjunker; 03-28-2017, 11:35 AM."I'm sorry, I didn't mean to upset you when I called you stupid. I thought you already knew..."
spammer police
USAF veteran
If your a veteran, join the KR veterans group
-
Thanks. I set them 2 & 1/8. Because at 2&1/2, my '95 Kat 750 didn't seem like it revved quickly enough like it was a tad rich (as if I could feel that). The drop down method seems like a lot of work to get back to "where everyone sets them". Is anyone here using a colortune?'95 gsx750F, '79 gs1000e '77 gs750
'83 xj550 maxim
'84 xvz1200
'78 cb750F3 & '76 FLH stroker
'80 fxs80 got whacked, only parts leftComment
Comment