Tweet
I'm chasing down puddles of fuel in my intake manifolds and decided to re-look at the emulsion tube O-rings. (between the slide support and the body.) When I rebuilt the carbs, I installed the 10mm X 1.5mm per the katana wiki but they crush down very little and seems I can install a 9.8mm x 1.9 mm (standard metric oring). Has anyone had issue with the 10mm X 1.5mm?? (an issue like puddles of gas in the intake manifolds). this part is not shown on the Suzuki parts list..
- If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.
Working...