Tweet
Hey all,
So exicted! My yoshimura full-system just arrived tonight and I'm amped to get 'er installed this weekend. Just going over the installation intrustions and had a quick question to run by you. They read:
"Tail section does not have a fixed mounting bracket, so it is necessary to adjust the tail section to the correct angle. Then drill a hole using a 3/16" drill bit thru center of punch hole and istall rivet, then slide the collector clamp over rivet and tighten."
So... it seems pretty self explanatory, given the parts. But is the rivet just held in place by the collector clamp?
I mean, or do I need to actually buh-buh-buh-buh-buh-buh-bludgeon it into submission rivet-style?
Many thanks!
N
So exicted! My yoshimura full-system just arrived tonight and I'm amped to get 'er installed this weekend. Just going over the installation intrustions and had a quick question to run by you. They read:
"Tail section does not have a fixed mounting bracket, so it is necessary to adjust the tail section to the correct angle. Then drill a hole using a 3/16" drill bit thru center of punch hole and istall rivet, then slide the collector clamp over rivet and tighten."
So... it seems pretty self explanatory, given the parts. But is the rivet just held in place by the collector clamp?
I mean, or do I need to actually buh-buh-buh-buh-buh-buh-bludgeon it into submission rivet-style?
Many thanks!
N