I have the owners manual for my 2000, but is there a book or info on what are the sizes for parts like bolts, snap rings etc.? The owners manual does not provide this info. Just torque specs. For instance I need to know the size of the snap ring that holds the clutch lever in place.
Ad Widget
Collapse
Announcement
Collapse
No announcement yet.
X
-
Yea. I'm just going to measure it and go with that. I wish there was some info readily available for sizes of the bolts etc. I have a bolt guage but black and white is a bit easier.
I had asked you about carbs. What I had done was pretty much a half A rebuild of mine. I changed jets, a few o rings and bowl gaskets. Dipped it in berrymans to clean. I didn't change all the o rings but have them all. I couldn't get the choke part apart without tearing up the screws so I left it alone. Didn't change the float needles or the jet that is behind the plug. The carbs are in good condition year 2000. I really want to have them done over like the stuff I didn't do. I'm contemplating. If I were to have it done I want to wait until after the summer. I have the slow dropping idle and I feel like its in the carbs. They say you are the man. So I may request your service if your willing to do it.
Comment
Comment