Carburation issues

[SurfinCR]

ok so i just got a set of carbs with "stage 3 setup" turned out they just had 120 jets in it nothing else was changed. so i took those jets and put them into mine, which i found out someone changed since it had new needles and open mixture screws however 112.5 jets.
i have it set at 3 turns on the mixture 120 main jets and 2nd notch on the needles. i had it on the 3rd but it didnt feel right.

so when i take it out the bike idles like a dream, low end the bike feels pretty good, feels like it could be better. now when i open the throttle it feels bogged down but then takes off, the bike does not smell rich.

whats the next step move up a notch down a notch?

thanks for any advice.

[SweetLou]

Move the clips UP a notch, that will lower the needles.

[SurfinCR]

just to make sure would it be wise to move it to the first notch?? or should i look into new needles?

[SweetLou]

Yeah, first notch is fine. If it doesn't work, try moving the other way 1 notch (compared to where it was before, so you would actually go to notches down from the top clip I guess you could say)

[md86]

Sounds like YOU need ....

http://factorypro.com/tech/carbtune,CV,high_rpm_engines.html

[pmkls1]

check out the thread crappy low end with jet kit, a lot of posts in there about that same problem.................